Metal supply air pipe with electric ventilation flap and sealing lip. The ventilation flap is opened or closed by alternately applying the mains voltage to the servomotor. As soon as the flap reaches its end point, the motor automatically stops at the stop. The connection to the mains voltage is made via a cable with 3 x 0.75 mm². Supply air damper with EPDM sealing lip is opened or closed by alternately applying the mains voltage to the servomotor. Motor stops automatically at the stop. Connection to the mains voltage is via a cable with 3 x 0.75 mm², control e.g. with KZS 200, light switch or manual adjustment with self-resetting pushbutton on the motor is possible (gear disengagement as long as the button is pressed). The seal is airtight according to DIN 1946 T4 (TÜV-tested) for pressurization or suction up to 1000 Pa. EPDM sealing lip is resistant to aging and weakly aggressive vapors and chemicals.
Can I also wall in the supply air dampers?
No, you should not do that, these dampers are not suitable for that. There are special pipe pieces with end flange, to this pipe you can then put on the inside of the supply air damper. In addition, any electrical device should be easily accessible and easy to replace at any time, because no device will last forever.
Performance features
- Electric ventilation flap with Belimo servo motor
- Sealing lip on the flap
- controlled open-close control possible
- for air flow control in ventilation and air conditioning systems
- Control via 230V mains voltage / KZS 200
Technical data
Operating voltage: | 100...240 V AC / 50-60 Hz |
Performance area: | max. 1.5 W / 3.5 VA |
Closing/opening time: | approx. 150 sec. (!) |
Working temperature: | 0° C / + 60 °C (max.) |
Protection class motor: | IP 54 |
Material tube: | Galvanised sheet steel |
Material sealing lip: | EPDM material |
Maximum pressure: | 1000 Pa |
Diameter Ø: | 100 mm |
WEEE NO.: EN91394868
Reviews
There are no reviews yet