The plastic (PP and ABS) flip float switch is reliable, maintenance and wear free, and can be mounted "from inside" a tank, canister, etc. This switch is built by ES: A reed contact is soldered to the high quality cable and potted together in the shaft with Wepuran®. The 230 volt version, which is not primarily intended for use on Schabus water detectors, can be used, for example, to switch a 230 V relay directly in the fuse box.
The 230 volt folding float switch may only be used in circuits that are protected by a residual current circuit breaker.
Performance features
- Material made of plastic (PP and ABS)
- Cable length 2.5 m (2×0.5mm²) Ölflex 108
- PG 9 thread
- Normally closed (NC) / normally open (NO) - By turning the float switch, the reverse contact function is obtained.
- Suitable for all liquids with a density of at least 0.7 g/cm³, e.g. water, heating oil, diesel, vegetable oil, lubricating oils, etc.
Â
Â
Technical data
| Electr. connection: | 2.5 m LAPP Ölflex smart 108 (2x 0.5 mm²) |
| Thread dimension: | M16 x 1.5 |
| Thread outer ø: | 16 mm |
| Shaft-ø: | 12 mm |
| Sealing ring ø: | 24 mm |
| Total length without cable: | approx. 85 - 86 mm, installation depth 57-58 mm |
| Switching function: | NC contact (NC) / NO contact (NO) |
| Switching voltage: | 230 V~ AC / 30 V= DC |
| Switching current / load: | max. 0.5 A / max. 10 Watt |
| Temperature range: | -20°. . . max. 80°C |
| Protection class: | IP 67 |
| Density v. Medium: | min 0.7g/cm³ |
| Print: | Unpressurised |
| Installation position: | horizontal |
Â
Reviews
There are no reviews yet.